Rig Welder Forums  

Go Back   Rig Welder Forums > Search Forums

Showing results 1 to 9 of 9
Search took 0.00 seconds.
Search: Posts Made By: Affende
Forum: Work 07-20-2016, 04:38 PM
Replies: 4
Views: 8,614
Posted By Affende
Re: Market $/hr pay Alberta Inspector.

$40 / hr for an AWS CWI?????? .... I need a new employer.

Payscale (which is historically fairly accurate) has the average pay for a CWI in the US as $26.75 / hour or about $58k per year .... but...
Forum: For Sale 07-14-2016, 05:07 PM
Replies: 3
Views: 5,093
Posted By Affende
Re: Alternator adjusting strap

All messages have been replied to. Thanks!

Sale Pending on the last two.
Forum: General Welding Questions 07-07-2016, 05:29 PM
Replies: 18
Views: 11,933
Posted By Affende
Re: tips for .045" Lincoln ultracore 71c

if its wanting to drip or build up in the middle, add more wire. T1C takes more wire than you are used to. 24V should be running smooth uphill. it should sound almost like a spray transfer.

I...
Forum: For Sale 07-07-2016, 05:21 PM
Replies: 3
Views: 5,093
Posted By Affende
Re: Alternator adjusting strap

Bump for the last 2.
Forum: For Sale 05-06-2016, 08:55 AM
Replies: 3
Views: 5,093
Posted By Affende
Re: Alternator adjusting strap

i have 4 of these left.
Forum: General Welding Questions 04-17-2016, 06:33 PM
Replies: 48
Views: 43,417
Posted By Affende
Re: F***ing porosity 7018

35 is low voltage for lohy. drop a gear and turn up your fine control.

run your xx10 rods high gear low range, lohy runs low gear high range
Forum: For Sale 04-17-2016, 01:25 PM
Replies: 3
Views: 5,093
Posted By Affende
Alternator adjusting strap

I got burnt by an online retailer that sold me a piece of shit for $35 ... so i designed my own and had a local waterjet cut one for my 69 redface. They have a minimum order so i ended up with a...
Forum: For Sale 11-11-2014, 06:57 PM
Replies: 0
Views: 2,885
Posted By Affende
F163 pistonss, rings, pins, and locks. full set. $175

F163 continental (4)pistons, (4 sets) rings, (4) wrist pins, (8)wrist pin locks.

$175 shipped anywhere in the lower 48.
Forum: Rigwelder.com Community Support 10-12-2014, 10:18 AM
Replies: 27
Views: 8,258
Posted By Affende
Re: up hill root

im doing the just the opposite. A lot of shop and plant work with uphill 6010 roots ... trying to hit pipe work after i get the 200 rebuilt as the plant work here isnt paying the bills.

I run...
Showing results 1 to 9 of 9

 
Forum Jump

All times are GMT -7. The time now is 12:32 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.